Ring Sizes

Choose The Correct Ring Size For Your Replica & Designer Jewelry

In order to print the ring sizer above, and get the most out of your replica jewelry, be sure that your printer is set to 100%. Make sure that you have not reduced the print size in your printer 'page setup' area. You can verify that the sizer printed correctly by measuring it with a ruler; it should measure from A to B: 3 1/2 inches long.

Once you have printed the sizer, follow these directions to find your ring size:

1. Cut out the ring sizer
2. Cut a slit for Slot "A"
3. With the numbers facing out, wrap the sizer around the finger where the ring will be worn.
4. Pull the pointed end Tab "B" through Slot "A" until the sizer is snug, making sure to allow size for the knuckle.
5. The number aligned with Slot "B" is your ring size.
6. If the measure lands between two numbers your size is a half size Ex: Between 5 and 6 ring size: 5.5. If half sizes are not available, order the next largest size.
7. Pick out your favourite piece of designer jewelry.